Videos

Video Transcript: Hi Guys, today we are going to show you how to fit a Blast Gate Damper into Spiral Ducting. Here we have a section of spiral and a blast gate damper (I have already broken down the Blast Gate by taking out the nuts and bolts). First, we need to identify where we want the Blast Gate Damper to sit. We are going to mark a ... Read more...

Video Transcript: Hi, today we are going to be joining two pieces of spiral ducting together. All you need is a male coupler and the spiral. The male coupler slides inside the spiral, and you can join a piece of spiral ducting on to the other end of the male coupler, like so. There are several ways that you can join and seal the ... Read more...

Video Transcript: Hi Guys! Today we will be comparing our two best selling types of Flexible Ducting. Both Flexible Ductings have a copper-plated steel wire trapped between two layers of polyurethane. The differences between the two are as follows: We will start with the wall thickness, these are both 100mm in diameter. The medium duty ... Read more...

Video Transcript: "Hi, in this video I am going to show you how the ductwork parts fit together. Here I have a selection of standard parts, all the standard parts are male ended. Meaning that a bend fits nicely inside the spiral ducting. If you are wanting to fit a selection of parts together, you will need a female connector. The female ... Read more...

Video Transcript: "Hi guys, In this video I will be showing you how to connect a saddle to a piece of spiral ducting. The spiral will need to be marked where you would like the saddle to sit. The best way to do this is to place the saddle on to the ducting and mark around the outside and around the inside, like so. Once the two marks... Read more...

Video Transcript: Hi guys, in this video I will be explaining how the unistrut bracket kit fits together.Here we have got a split clip, some threaded rod, channel nuts, top plates and M10 nuts.Take a piece of M10 rod and wind a nut on to each end, approximately 15-20mm down the length.Then drop a top plate on with the bends facing downwards and a ... Read more...